Steve Adams Adams Business Services Owner

Bill,

Not directly.  To get it to change to the lowest counter for that prefix you have to move it to another sheet and update the labels.  Then move it back and update the labels again.  You must renumber the model before you do this, so it can find the lowest counter needed.

Steve Adams

James,

Not sure this is what you need, but if you use the Search Filter to selecat all Main Parts you can change more than one item at a time.  Just change the main parts behavior from 1 to the explicit quantity you need.  Its not a global way to change the quantities, but it would be faster than one piece at a time.

Steve Adams

Bill,

The attribute in your Page header of the prototype needs to be changed.  It is set to DATE_DRAW, which is Date of created drawing.  To get it to use the Date of order change the attribute to DATE_ORDER.  This will change the date to what you want to set the new date to, with a page header update.

Steve

Bill,

It appears you need to turn off the Broken dimension line.  Go to your DS manager to the dimension line you added.  In the "View Dimensions" click on the Settings box in the dimension you need to fix.  In that dialog is a check next to the Broken dimension line.  Uncheck this and it should put the line in.  Also, if you want that dimension centered change the Linear, ordinate to Linear, relative.  This will also put the line in as well as center the dimension for you.  Hope this helps.

Steve Adams

Has anyone found a work around for the fact that you can't do a right side only clip angle?  This was reported as a bug a long time ago and confirmed by Graitec, but still no fix has been provided.  Any suggestion on a quick way to work around this problem would be appreciated.

Steve