I noticed a good improvement on railing pipe end connection when using plat. Thanks for effort . However to make this connection more powerful I have the following requests:
A-Plates can be both sides too.
B-If plate is used at the back of pipe I like to see an option for through plate also.
C-Plates shall have an option to extend or reduce from outer face of pipe.
D-Besides weld connection plate to post, bolting option to be added.
E-Bolt connection option shall be added to angle (NS/FS/BS) & "T" section too.
F-When plate is used as through plate, post will be cut (slot cut) automatically.
Please see attached file.
Regards,
Greg Daneshvar
Attachment: [file not found]
