Posted Mon, 21 Dec 2015 21:09:34 GMT by Michael Prather Abuck, inc Fabrication Manager/Detailer
With Advance steel 2016, is there a way to break a project
into different phases? And if there is, what are the steps?
Posted Mon, 21 Dec 2015 21:23:28 GMT by Tommy Moussis Graitec USA Inc.
Michael, yes you can. In the Advance Properties of any member in advance steel, under the "naming" tab, you can apply a value in the "Lot/Phase" cell. Also, you can check off the box to the left hand side to control whether or not you would like the same mark to appear for an assembly in two different phases. If the box is checked and you then apply piece marks to your model, typical assemblies that are in phase 1 and phase 2 will not have the same part mark. Best regards

Attachment: Phase numbers.png

You must be signed in to post in this forum.

GRAITEC Services
Free Trial
GRAITEC Products
Advance Design
Advance Workshop
Advance BIM Designers
PowerPack for Revit®
PowerPack for Advance Steel
Autodesk Products
Cloud services
Advance Steel

GRAITEC GROUP 2018 | WE'VE UPDATED OUR PRIVACY NOTICE - Click here to find out more about how we collect, store and handle your personal data and your rights.